Simply connect the Inputs using suitable wire or cable (shielded cable is recommended) from your input connectors to the UVC Module. Connections are labeled on the PCB. Make sure the sockets used do not allow electrical contact between RCA Socket ground and the chassis. Connect each RCA input pairs ground connection to the middleRead More
1 – Mounting & connecting the Control Matrix
–1.1 Mounting the Control Matrix –1.2 Power Supply Wiring –1.3 Connecting the Ribbon Cables 1.1 – Mounting the Control Matrix If using a pre-machined front panel, simply mount the Control Matrix PCB using the supplied hardware. It is not necessary to fit the ribbon cables between Logic/PSU Module and the Volume Control and Selector ModuleRead More
CSS Manual
CSS The indicated trace is cut and resistor placed across it to prevent oscillation. Resistor from 1K to 5K is acceptable Connect B+ as shown, or optionally a 1ohm resistor can be connected from that trace to the trace labelled B+. In that case B+ connects to the labelled B+ Connect anode as shownRead More
Saffier’s Sabre DAC in Granite Case
Just wanted to share my “almost” end result of the DAC project. The Buffalo DAC 24bit/192Khz with UST output stage. A second (UST) unit is being planned so I can use the current output of the DAC instead of the voltage output. Should give even better detail and texture. Sound is great. See pictures attached.Read More
The Clock” & “The Power” Installation Manual
Contents: –A. 1ppm TCXO Oscillator –B: “The Clock” –C. “The Power” –D. “The Clock” and “The Power” completed A. 1ppm TCXO Oscillator 1. Fit the 1ppm TCXO oscillator into ‘The Clock” oscillator socket (Y1). Note: Observe orientation. Pin 1 of the TCXO oscillator shall align with the square corner of the silk print. UNDERRead More
Wiring the chassis and Modules
4 – Wiring the chassis and Modules Please check your Kit content against the list to the right. Take care to first review the steps outlined below, assemble the necessary tools, parts etc. Many of the required connections can be made without using a soldering iron. However the connections for the RCA Jacks and fromRead More
Appendix 4
Appendix 4 –The UVC/UTS based 2 Channel active Linestage –Backplate Mounting of Power Switch –Optional Side Plate Mounting of power Switch The UVC/UTS based 2 Channel Active Linestage The chassis has 3 boards. For reference they are 1. Audio board closest to RCA jacks, 2. Control matrix board on the front panel and 3.Read More
Protected: Chapter 5 – TVC theory and Application
There is no excerpt because this is a protected post.
Projekt-Universal Tube Output EZ Linestage Manual
Projekt-Universal Tube Output EZ Linestage Manual Table of Contents Projekt-Universal Tube Output EZ Linestage Manual Electrical Performance 1.1 – Settings and Input wiring for use as SE Linestage 6db Gain 1.2 – Settings and Input wiring for use as SE Linestage 12db Gain Introduction and Overview The diyhifisupply® Universal Tube Output Stage hasRead More
AVC Analyzer Test
AVC -10db into 100k AVC -20db into 100k AVC -30db into 100k AVC -40db into 100k RightMark Audio Analyzer test Testing chain: External loopback (line-out – line-in) Sampling mode: 24-bit, 192 kHz Summary Frequency response Noise level Dynamic range THD + Noise (at -3 dB FS) Intermodulation distortion Stereo crosstalk This report was generatedRead More