Super Regulators There are two “Super Regulators” on “The Clock”. One Super Regulator powers the clock circuit, the other power the special unique buffer section. The regulators use very low noise operational amplifiers, offering a noise performance near the limits of what can be achieved without permanently super cooling the circuit in liquid nitrogen. The Super Regulators also uses the lowest noise voltage reference available (LM329), offering 75nV|/Hz noise performance. This ultra low noise voltage reference is used together with a two-stage low pass, which filters the noise from the reference by a factor of 100 at 1Hz and by a factor of 2500 at 10Hz. The combination makes the lowest noise reference possible for the Super Regulators. More crucially, this performance is maintained even at very low frequencies (< 10Hz). It is the very low frequency noise that tends to dominate jitter in a well designed clock and is very hard to control. Unique buffered output Any clock oscillator’s performance is degraded when being asked to directly drive logic inputs, circuit traces and wiring, some oscillators will not even work at all if loaded too much. Fitting high current, high impedance buffers within millimeters after “The Clock” ensures “The Clock” oscillator operates without any significant load at all. The result is a clock where the theoretical performance of “The Clock” oscillator is realised as it operates into a load and with a power supply that is as close to theoretically perfect as can be made. The Output Buffer drives two separate outputs, one a special circuit that emulates the normal clock crystal found in most players and another that offers an output compatible with the less common 4-Pin “canned oscillator” type. The Crystal Emulation output is not designed to source or sink significant currents. The XO type output can drive up to +/-10mA.
Despite being rated at a low 1.2VA output (12V/0.1A), “The Power” uses an oversized 6VA transformer. The transformer is fitted with a special electrostatic screen to ensure lowest noise possible. It uses Full Wave Rectification (not bridge) with two noiseless schottky diodes. It uses chokes filter on the input. It uses a CRCRC power supply filter with 3,000uF total capacitance. It uses a special low noise 12V regulator. The Circuit Design in “The Power” parallels that of a power supply used for a high-end tube preamp, but scaled to the appropriate voltages for “The Clock”.