by Jasmin | May 26, 2022 | z
–1.1 Mounting the Control Matrix –1.2 Power Supply Wiring –1.3 Connecting the Ribbon Cables 1.1 – Mounting the Control Matrix If using a pre-machined front panel, simply mount the Control Matrix PCB using the supplied hardware. It is not necessary to fit the ribbon...
by Jasmin | May 26, 2022 | Manual
CSS The indicated trace is cut and resistor placed across it to prevent oscillation. Resistor from 1K to 5K is acceptable Connect B+ as shown, or optionally a 1ohm resistor can be connected from that trace to the trace labelled B+. In that case B+ connects to...
by Jasmin | May 26, 2022 | References, Review
DESIGN: Belden’s patented bonded pair technology has always been a cornerstone of stable electrical performance. With Media Twist, Belden taken pair technology a step further. Through Belden’s unique crescent shape design, each pair is “locked” into place. This...
by Jasmin | May 26, 2022 | Showcase
Just wanted to share my “almost” end result of the DAC project. The Buffalo DAC 24bit/192Khz with UST output stage. A second (UST) unit is being planned so I can use the current output of the DAC instead of the voltage output. Should give even better detail and...
by Jasmin | May 26, 2022 | Manual
Contents: –A. 1ppm TCXO Oscillator –B: “The Clock” –C. “The Power” –D. “The Clock” and “The Power” completed A. 1ppm TCXO Oscillator 1. Fit the 1ppm TCXO oscillator into ‘The Clock” oscillator socket (Y1). Note: Observe orientation. Pin 1 of the TCXO...
